Vortex Silver Series Instrukcja Użytkownika Pobierz pdf (Strona 18)

VORTEX

SILVER SERIES

USER MANUAL

VORTEX SILVER SERIES V8

P.17

4.4 Main Menu

To switch the amplifier off use the Power menu.

All settings important for operation of the amplifier are accessible in the

Settings menu.

Information about operating state of the amplifier like Temperature, Output

Signal, Configuration Overview, and Network Overview are accessible in

the Monitor menu.

Adjustments for display brightness and contrast will be done in menu Dis-

play.

A temporary lock of the touch-sensitive elements to prevent unintentional

changes is accessible through the Lock Device menu.

The serial number and current firmware version of your V8 are displayed

in the System Info.

Please consult the V8 Navigation Guide for details about the menu. You

can always find the current V8 Navigation Guide on our website camco-

audio.com.

4.5 Input/Output

4.5.1 Input Selection

Due to the fact that the V8 amplifier has a U

man

Digital Audio Network

Interface which is built-in and ready to use, there are three different Input

selections possible:

Analog

In this mode analog signals connected to the XLR Input connectors at the

back of the amplifier will be used as input signal.

Digital

With the digital setting input signals are taken from the U

man

Digital Audio

Network Interface.

Digital with Analog fallback

For normal operation the input signals are taken from the U

man

Digital

Audio Network Interface. In case of a disconnection or failure of the Digital

Audio Network the fallback mode automatically switches over to the ana-

log inputs and gives you an extra portion of redundancy.

4.5.2 Output Mode

There are three different Output Modes available:

Dual Channel Operation

Mono Bridge Operation

Parallel Mono Operation

For more information about Output Modes please see section 3.3.

4.6 Amp Gain and Input Sensitivity

The V8 amplifier has a 26 dB and 32 dB voltage gain setting along with a

1,4 V sensitivity setting.

The table shows input sensitivity per channel for a given gain and load. It

also shows the gain for the 1,4 V input sensitivity.

Model 26 dB 32 dB 1,4 V

V8 4000 W @ 2 Ω

3800 W @ 4 Ω

2200 W @ 8 Ω

4,48 V

6,18 V

6,65 V

2,24 V

3,10 V

3,33 V

39,8 dB

4.7 DSP

With the optional DSP-Board installed you can route the DSP into the sig-

nal chain (DSP On) or bypass the complete DSP section (DSP Off).

For more information regarding DSP functionality and Remote Control of

the Amplifier please visit www.camcoaudio.com.

4 OPERATION

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Komentarze do niniejszej Instrukcji

Brak uwag

Vortex Silver Series Instrukcja Użytkownika Strona 18

Komentarze do niniejszej Instrukcji